J1939 · Aftertreatment - SCR/DEF
SPN 3364 FMI 18
DEF quality low, moderately severe
What does SPN 3364 FMI 18 mean?
The DEF quality sensor reports poor concentration at the moderately severe level. Bad DEF leads to poor NOx conversion and eventual inducement. Urgency: check soon - the machine may derate or limit a function. Check first: test the DEF in the tank with a refractometer and compare it with clean DEF.
- FMI 18
- Below normal, moderately severe
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Test the DEF in the tank with a refractometer and compare it with clean DEF
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- DEF diluted with water
- Sensor in the tank reading wrongly
- Water or contamination in the tank
- Wrong fluid added at the last fill
How it failed
You'll notice: The DEF quality sensor reports poor concentration at the moderately severe level, so NOx conversion drops and inducement may follow if the fluid is not replaced.
Real conditionRead from FMI 18: below normal, moderately severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3364 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 3364 with FMI 18. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
