EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 4331 Fault Code

Aftertreatment SCR actual dosing reagent quantity

What does SPN 4331 mean?

The amount of DEF the dosing system actually injects, compared with the ECM's target. It is used to catch under- or over-dosing. How urgent it is depends on the FMI after SPN 4331 - pick it below. Check first: read the commanded dose against the measured dose in the service tool during the dosing test.

FaultActiveSPN 4331FMI --J1939 engine ECU
SPN 4331
Aftertreatment SCR actual dosing reagent quantity
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 4331 - pick it below.

What should I check first?

Read the commanded dose against the measured dose in the service tool during the dosing test

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 4331?

You'll notice: The DEF dose actually delivered does not match the target, so the SCR cannot cut NOx as it should.

Find the number shown after SPN 4331 on your display.

  • 15SPN 4331 FMI 15: DEF dosing quantity is lower than the targetReal conditionDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
  • 16SPN 4331 FMI 16: DEF dosing quantity is higher than the targetReal conditionDetroit DD15
  • 18SPN 4331 FMI 18: Value is below the normal range, moderately severe levelReal conditionCummins ISX15
  • 19SPN 4331 FMI 19: The SCR dosing quantity message arrived in error over CANLost messagePACCAR MX-13

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 4331 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Dosing valve partly blocked by crystals, delivering less than commanded
  • DEF supply pressure low from a weak pump, a clogged filter or a leaking line
  • Air in the DEF supply from a low tank or a loose fitting, so the dose is erratic
  • Dosing valve leaking or stuck open, delivering more than commanded

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 4331 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.