EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 4096 Fault Code

Aftertreatment 1 diesel exhaust fluid tank empty

What does SPN 4096 mean?

A status that the DEF tank is empty (level below the usable minimum). It starts the inducement countdown, from derate to speed limit, in emissions-regulated markets. How urgent it is depends on the FMI after SPN 4096 - pick it below. Check first: look into the tank and add the correct DEF, then watch the gauge and the lamp.

FaultActiveSPN 4096FMI --J1939 engine ECU
SPN 4096
Aftertreatment 1 diesel exhaust fluid tank empty
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 4096 - pick it below.

What should I check first?

Look into the tank and add the correct DEF, then watch the gauge and the lamp

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 4096?

You'll notice: The DEF tank is empty, so the ECM warns and then starts operator inducement: power is cut and a speed limit follows if the tank is not refilled.

Find the number shown after SPN 4096 on your display.

  • 31SPN 4096 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionCummins ISX15

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 4096 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • DEF tank really empty after the warnings were ignored
  • DEF level sender reading empty on a tank that has fluid, from a stuck float or a corroded plug
  • DEF leak at a line fitting, the pump module or the tank, so the tank empties quickly
  • Fluid frozen around the sender, so the level reads empty on a cold machine

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 4096 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.