EF Logo

J1939 · Aftertreatment - SCR/DEF

SPN 3360 Fault Code

Aftertreatment 1 diesel exhaust fluid controller

What does SPN 3360 mean?

The controller that runs the DEF dosing and heating system and talks to the engine ECM over the data link. It reports dosing, tank and heater status. How urgent it is depends on the FMI after SPN 3360 - pick it below. Check first: check the controller power and ground with the key on.

FaultActiveSPN 3360FMI --J1939 engine ECU
SPN 3360
Aftertreatment 1 diesel exhaust fluid controller
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 3360 - pick it below.

What should I check first?

Check the controller power and ground with the key on

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 3360?

You'll notice: The DEF controller has a fault, so DEF dosing may be wrong or stop: you see the SCR lamp, a derate and possibly an inducement warning.

Find the number shown after SPN 3360 on your display.

  • 2SPN 3360 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15
  • 9SPN 3360 FMI 9: Abnormal update rate: the signal or message is late or missingLost messageCummins ISX15
  • 11SPN 3360 FMI 11: A fault exists but the ECM cannot identify its causeOtherCummins ISX15
  • 12SPN 3360 FMI 12: Bad intelligent device or componentPart or controllerCummins ISX15
  • 13SPN 3360 FMI 13: The value is out of calibrationPart or controllerCummins ISX15
  • 19SPN 3360 FMI 19: Network data for this parameter was received in errorLost messageCummins ISX15

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 3360 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Controller power or ground fault from a corroded plug or a blown fuse
  • CAN link between the controller and the ECM faulty
  • Controller internal failure or corrupt software
  • Wiring fault at the controller connector, such as spread pins or water

Source

Cummins ISX15 2010-2012 fault code list (Diesel Laptops)

This list names SPN 3360 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2010-2012) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.