EF Logo

Deutz · High-pressure fuel system

Deutz Fault Code SPN 523615 FMI 3

Engine - Fuel metering unit - Voltage above normal or shorted to high source

What does Deutz code SPN 523615 FMI 3 mean?

The EMR4 sees the output for the fuel metering unit (FMU) (on the high-pressure pump, where it meters fuel into the pump) at a voltage above normal, as if the circuit is shorted to the battery supply. The controller cannot drive the actuator correctly. Urgency: stop now - shut down and fix before working on. Check first: measure the winding or coil resistance of the part.

FaultStopSPN 523615FMI 3Deutz · High-pressure fuel system
SPN 523615
What is at fault
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Measure the winding or coil resistance of the part

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Read the active and stored faults with Deutz SerDia (or the machine maker's diagnostic tool) on the engine diagnostic plug.

Checks

0 of 4 done

Causes

  • Connector on the high-pressure pump soaked in diesel
  • Fuel metering unit (FMU) shorted internally
  • Connector pin touching a live pin

How it failed

You'll notice: Expect a warning lamp; the EMR4 cannot regulate rail pressure: the engine may not start, run rough or stop, and it can go into limp mode.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Common rail: metering unit, pre-feed pump, relief valve and rail pressure

2 other codes on this part are also shorted high (SPN 157 FMI 3, SPN 523906 FMI 3). When they show together, start at the wiring and connector they share.

Show the other 13 codes
All 22 Common rail: metering unit, pre-feed pump, relief valve and rail pressure codes on one page

Source

DEUTZ KWP-Codes EMR4 (KWPList EMR4 DE EN, Revision 2.0), page 10

This source lists SPN 523615 FMI 3 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Deutz engines with the EMR4 controller (the Deutz list applies to all EMR4 engine series, e.g. TCD 2.9, 3.6, 4.1, 6.1, 7.8 as fitted in machines).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.