EF Logo

Deutz · High-pressure fuel system

Deutz Fault Code SPN 164 FMI 2

Engine - Rail pressure - Data erratic intermittent or incorrect

What does Deutz code SPN 164 FMI 2 mean?

The EMR4 sees the rail pressure signal erratic. The common rail pressure swings or fails a plausibility check, so the controller cannot hold a steady pressure. Urgency: check soon - the machine may derate or limit a function. Check first: bleed the low-pressure side and check for air at the suction side of the feed pump.

FaultCheckSPN 164FMI 2Deutz · High-pressure fuel system
FMI 2
Erratic or incorrect data

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Bleed the low-pressure side and check for air at the suction side of the feed pump

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Read the active and stored faults with Deutz SerDia (or the machine maker's diagnostic tool) on the engine diagnostic plug.

Checks

0 of 4 done

Causes

  • Air in the fuel or a starved high-pressure pump
  • Failing rail pressure sensor with a noisy signal
  • Intermittent sensor connector contact
  • Worn high-pressure pump losing pressure under load

How it failed

You'll notice: Rough running, loss of power and sometimes a stall under load; the warning lamp comes on.

Erratic or implausibleRead from FMI 2: erratic or incorrect data

The reading jumps, drifts or disagrees with the sensors around it.

allowed rangetime
The reading against the band the controller allows.
Meter test
Watch the live value on the service tool while you flex the harness and tap the connector.
Good result
A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Common rail: metering unit, pre-feed pump, relief valve and rail pressure

3 other codes on this part are also erratic or implausible (SPN 523009 FMI 10, SPN 523470 FMI 2, SPN 523613 FMI 2). When they show together, start at the wiring and connector they share.

Show the other 13 codes
All 22 Common rail: metering unit, pre-feed pump, relief valve and rail pressure codes on one page

Source

DEUTZ KWP-Codes EMR4 (KWPList EMR4 DE EN, Revision 2.0), page 30

This source lists SPN 164 FMI 2 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Deutz engines with the EMR4 controller (the Deutz list applies to all EMR4 engine series, e.g. TCD 2.9, 3.6, 4.1, 6.1, 7.8 as fitted in machines).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.