EF Logo

Cat · Engine sensors

Cat Fault Code CID 91 FMI 03

Throttle position sensor voltage high

What does Cat code CID 91 FMI 03 mean?

The engine ECM sees the throttle position signal above its upper limit. The 924H manual lists the engine harness shorted to voltage, the lower cab harness shorted to voltage, or the ECM. Urgency: check soon - the machine may derate or limit a function. Check first: connect Cat ET and watch for 91-3 while starting or trying to start the engine.

FaultCheckCID 91FMI 03Cat · Engine sensors
CID 91
Which component is at fault
FMI 03
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Connect Cat ET and watch for 91-3 while starting or trying to start the engine.

Then 4 more checks
Code shows hereFAULTCID 91FMI 03

Where this code shows

Turn the key on and check the cluster or monitor for a warning lamp.

Checks

0 of 5 done

Causes

  • Engine wiring harness signal wire shorted to a supply
  • Lower cab harness shorted to voltage
  • Throttle sensor supply shorted into the signal
  • Engine ECM

How it failed

You'll notice: Engine speed may not follow the pedal or may sit at one speed.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine sensors and sensor supply

Source

TM 5-3805-298-23-1 Field Maintenance Manual, 924H Wheel Loader, troubleshooting tables (CID 91 FMI 03)

This source lists CID 91 FMI 03 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cat 924H wheel loader with C6.6 engine (engine ECM), per the 924H field maintenance manual; the same CID-FMI scheme is used on other Cat machines with C-series ECMs.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.