Cat · Engine sensors
Cat Fault Code CID 91 FMI 04
Throttle position sensor voltage low
What does Cat code CID 91 FMI 04 mean?
The throttle position signal fell below the ECM's lower limit. The manual lists the engine harness shorted to ground, the lower cab harness shorted to ground, or the engine ECM. Urgency: check soon - the machine may derate or limit a function. Check first: start or try to start the engine with Cat ET connected and confirm 91-4 is active.
- CID 91
- Which component is at fault
- FMI 04
- Voltage below normal or shorted low
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Start or try to start the engine with Cat ET connected and confirm 91-4 is active.
Then 4 more checksWhere this code shows
Turn the key on and check the cluster or monitor for a warning lamp.
Checks
0 of 5 done
Causes
- Engine wiring harness signal wire shorted to ground
- Lower cab harness chafed to the frame
- Open or shorted sensor supply (41) pulling the signal down
- Engine ECM
How it failed
You'll notice: Throttle response is lost or the engine drops to low idle regardless of pedal position.
Shorted lowRead from FMI 4: voltage below normal or shorted low
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Engine sensors and sensor supply
4 other codes on this part are also shorted low (CID 100 FMI 04, CID 110 FMI 04, CID 172 FMI 04, CID 1785 FMI 04). When they show together, start at the wiring and connector they share.
- CID 41 FMI 038 V sensor supply voltage highShorted highCheck soon
- CID 91 FMI 03Throttle position sensor voltage highShorted highCheck soon
- CID 91 FMI 04Throttle position sensor voltage lowShorted lowCheck soon
- CID 100 FMI 03Engine oil pressure sensor voltage highShorted highCheck soon
- CID 100 FMI 04Engine oil pressure sensor voltage lowShorted lowCheck soon
- CID 110 FMI 03Engine coolant temperature sensor voltage highShorted highCheck soon
- CID 110 FMI 04Engine coolant temperature sensor voltage lowShorted lowCheck soon
- CID 172 FMI 03Intake manifold air temperature sensor voltage highShorted highCheck soon
- CID 172 FMI 04Intake manifold air temperature sensor voltage lowShorted lowCheck soon
Show the other 8 codesHide the other codes
- CID 262 FMI 035 V sensor supply voltage highShorted highCheck soon
- E360Low engine oil pressureOtherStop now
- E361High engine coolant temperatureOtherStop now
- E539High intake manifold temperatureReal conditionCheck soon
- E1044High intake manifold pressureOtherCheck soon
- E1045Low intake manifold pressureOtherCheck soon
- CID 1785 FMI 03Intake manifold pressure sensor voltage highShorted highCheck soon
- CID 1785 FMI 04Intake manifold pressure sensor voltage lowShorted lowCheck soon
Related on Equipments Finder
Source
This source lists CID 91 FMI 04 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Cat 924H wheel loader with C6.6 engine (engine ECM), per the 924H field maintenance manual; the same CID-FMI scheme is used on other Cat machines with C-series ECMs.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
