EF Logo

Cat · Engine sensors

Cat Fault Code CID 41 FMI 03

8 V sensor supply voltage high

What does Cat code CID 41 FMI 03 mean?

The engine ECM's 8 V sensor supply read above 8.8 V for more than one second. That supply powers the throttle position sensor, so a short to voltage here also upsets throttle readings. Urgency: check soon - the machine may derate or limit a function. Check first: connect Cat ET and start or try to start the engine; confirm 41-3 is active.

FaultCheckCID 41FMI 03Cat · Engine sensors
CID 41
Which component is at fault
FMI 03
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Connect Cat ET and start or try to start the engine; confirm 41-3 is active.

Then 4 more checks
Code shows hereFAULTCID 41FMI 03

Where this code shows

Turn the key on and check the cluster or monitor for a warning lamp.

Checks

0 of 5 done

Causes

  • Engine wiring harness shorted to voltage
  • Lower cab wiring harness shorted to voltage
  • Engine ECM supply output fault

How it failed

You'll notice: Throttle position or other sensors may read wrongly and the engine can derate or run at a fixed speed.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine sensors and sensor supply

Source

TM 5-3805-298-23-1 Field Maintenance Manual, 924H Wheel Loader, troubleshooting tables (CID 41 FMI 03)

This source lists CID 41 FMI 03 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cat 924H wheel loader with C6.6 engine (engine ECM), per the 924H field maintenance manual; the same CID-FMI scheme is used on other Cat machines with C-series ECMs.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.