EF Logo

Cat · Engine sensors

Cat Fault Code CID 110 FMI 04

Engine coolant temperature sensor voltage low

What does Cat code CID 110 FMI 04 mean?

The coolant temperature signal dropped below 0.2 V for more than eight seconds. The manual lists the harness shorted to ground, a shorted sensor, or the engine ECM. Urgency: check soon - the machine may derate or limit a function. Check first: confirm 110-4 is active and compare the Cat ET temperature with a thermometer reading on the coolant hose.

FaultCheckCID 110FMI 04Cat · Engine sensors
CID 110
Which component is at fault
FMI 04
Voltage below normal or shorted low

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Confirm 110-4 is active and compare the Cat ET temperature with a thermometer reading on the coolant hose.

Then 4 more checks
Code shows hereFAULTCID 110FMI 04

Where this code shows

Turn the key on and check the cluster or monitor for a warning lamp.

Checks

0 of 5 done

Causes

  • Engine control harness shorted to ground
  • Coolant temperature sensor shorted internally
  • Engine ECM

How it failed

You'll notice: The ECM may think the engine is very hot, so the gauge can read high and a high coolant temperature event can appear with a cool engine.

Shorted lowRead from FMI 4: voltage below normal or shorted low

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine sensors and sensor supply

Source

TM 5-3805-298-23-1 Field Maintenance Manual, 924H Wheel Loader, troubleshooting tables (CID 110 FMI 04)

This source lists CID 110 FMI 04 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cat 924H wheel loader with C6.6 engine (engine ECM), per the 924H field maintenance manual; the same CID-FMI scheme is used on other Cat machines with C-series ECMs.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.