EF Logo

Cat · Engine sensors

Cat Fault Code CID 110 FMI 03

Engine coolant temperature sensor voltage high

What does Cat code CID 110 FMI 03 mean?

The coolant temperature signal went above 4.95 V for more than eight seconds. The manual lists an engine harness open or shorted to a supply, the sensor shorted to supply voltage, or the ECM. Urgency: check soon - the machine may derate or limit a function. Check first: connect Cat ET and confirm 110-3 is active with the engine running, not only logged.

FaultCheckCID 110FMI 03Cat · Engine sensors
CID 110
Which component is at fault
FMI 03
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Connect Cat ET and confirm 110-3 is active with the engine running, not only logged.

Then 4 more checks
Code shows hereFAULTCID 110FMI 03

Where this code shows

Turn the key on and check the cluster or monitor for a warning lamp.

Checks

0 of 5 done

Causes

  • Engine harness open or shorted to a power source
  • Coolant temperature sensor shorted to supply voltage
  • Engine ECM

How it failed

You'll notice: The temperature gauge shows nothing or pegs cold, white smoke at start-up is possible, and the fan may run on a default.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine sensors and sensor supply

Source

TM 5-3805-298-23-1 Field Maintenance Manual, 924H Wheel Loader, troubleshooting tables (CID 110 FMI 03)

This source lists CID 110 FMI 03 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cat 924H wheel loader with C6.6 engine (engine ECM), per the 924H field maintenance manual; the same CID-FMI scheme is used on other Cat machines with C-series ECMs.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.