EF Logo

Bobcat · Engine

Bobcat Fault Code M0810

Engine coolant temperature too high

What does Bobcat code M0810 mean?

Coolant is hotter than normal. Reduce load and let it idle to cool while you check the cooling system. Urgency: check soon - the machine may derate or limit a function. Check first: clean the radiator, oil cooler and screen of dirt, chaff and oil film so air can pass.

FaultCheckM0810Bobcat · Engine

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Clean the radiator, oil cooler and screen of dirt, chaff and oil film so air can pass

Then 3 more checks
Code shows hereFAULTM0810

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 4 done

Causes

  • Thermostat stuck closed
  • Low coolant level or a leak
  • Cooling fan or shroud damaged
  • Loose or slipping fan belt

How it failed

You'll notice: The engine coolant temperature is high.

Real conditionRead from how the source describes the code

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine oil pressure, coolant and air temperature

4 other codes on this part are also real condition (M0409, M0811, M0821, M0822). When they show together, start at the wiring and connector they share.

Show the other 19 codes
All 28 Engine oil pressure, coolant and air temperature codes on one page

Source

Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)

This source lists M0810 and its meaning. The guidance on this page is general, not taken from it.

The source covers: M-Series loaders (S450-S850, T450-T870) and M-Series excavators (E26-E85).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.