EF Logo

Bobcat · Engine

Bobcat Fault Code M0415

Engine oil pressure shutdown

What does Bobcat code M0415 mean?

The controller has shut the engine down on very low oil pressure to prevent bearing damage. Urgency: stop now - shut down and fix before working on. Check first: review the service record for oil type and filter change; the wrong grade or old oil has less film strength when hot.

FaultStopM0415Bobcat · Engine

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Review the service record for oil type and filter change; the wrong grade or old oil has less film strength when hot

Then 3 more checks
Code shows hereFAULTM0415

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 4 done

Causes

  • Severe bearing wear
  • Failed oil pump or blocked pickup
  • Burst oil line or loose filter
  • Oil pressure sender giving a false low signal

How it failed

You'll notice: The engine was stopped by the controller on low oil pressure.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine oil pressure, coolant and air temperature

Show the other 19 codes
All 28 Engine oil pressure, coolant and air temperature codes on one page

Source

Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)

This source lists M0415 and its meaning. The guidance on this page is general, not taken from it.

The source covers: M-Series loaders (S450-S850, T450-T870) and M-Series excavators (E26-E85).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.