EF Logo

Bobcat · Operator presence

Bobcat Fault Code 11‑06

Seat bar sensor short to ground

What does Bobcat code 11-06 mean?

The seat bar sensor circuit is shorted to ground. Lift, tilt and traction may lock out because the controller cannot confirm the operator is seated. Urgency: check soon - the machine may derate or limit a function. Check first: check for a loose ring terminal or ground strap touching the sensor circuit.

FaultCheck11-06Bobcat · Operator presence

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check for a loose ring terminal or ground strap touching the sensor circuit

Then 3 more checks
Code shows hereFAULT11-06

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 4 done

Causes

  • Sensor wire chafed to the frame or ground
  • Moisture in the connector
  • Plug or harness pinched at the pivot
  • Sensor internal short to ground

How it failed

You'll notice: Lift, tilt and travel may be disabled because the seat bar sensor circuit is shorted to ground.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Seat bar, press to operate, cab door and door lock

2 other codes on this part are also shorted low (M5306, H7903). When they show together, start at the wiring and connector they share.

Show the other 15 codes
All 24 Seat bar, press to operate, cab door and door lock codes on one page

Source

Bobcat S205 Operation & Maintenance Manual, service codes (flash count table)

This source lists 11-06 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Older Bobcat skid-steer and track loaders using the two-digit service codes (S205 manual, similar models).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.