Volvo/Mack · MID 128 engine ECU - aftertreatment (DPF, DEF, NOx)
Volvo/Mack Fault Code MID 128 PPID 337 FMI 0
DPF ash level too high
What does Volvo/Mack code MID 128 PPID 337 FMI 0 mean?
The DPF ash load is above the limit. Mack says the filter needs service because the ash level is too high. Urgency: information - a reminder or status message. Check first: check the DPF ash level in the scan tool for damage, corrosion or looseness.
- MID 128
- Which control unit reports it
- PPID 337
- Maker parameter at fault
- FMI 0
- Data above normal, most severe
Can I keep running with it?
Information
A reminder or status message. Nothing is failing yet.
What should I check first?
Check the DPF ash level in the scan tool for damage, corrosion or looseness
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- DPF ash load beyond the service limit from normal use
- High oil consumption adding ash to the filter faster than normal
- Filter cleaning interval overdue
How it failed
You'll notice: Yellow check lamp lit; regenerations get closer together until the filter is cleaned.
Real conditionRead from FMI 0: data above normal, most severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 128 engine ECU - aftertreatment (DPF, DEF, NOx)
- MID 128 PPID 326 FMI 11DPF soot level critically high
- MID 128 PSID 46 FMI 0SCR system severe fault - operator inducement
- MID 128 PSID 47 FMI 0Unable to reach regeneration temperature
- MID 128 PSID 47 FMI 1Aftertreatment temperature too high during regeneration
- MID 128 PID 81 FMI 0DPF differential pressure critically high
- MID 128 PID 81 FMI 3DPF differential pressure sensor signal high
- MID 128 PID 81 FMI 5DPF differential pressure sensor circuit open
- MID 128 PSID 90 FMI 1DEF dosing too low - NOx limits exceeded, poor DEF quality
Related on Equipments Finder
Source
This source lists MID 128 PPID 337 FMI 0 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
