EF Logo

Volvo/Mack · MID 128 engine ECU - sensors and levels

Volvo/Mack Fault Code MID 128 PID 110 FMI 4

Engine coolant temperature sensor signal low or shorted to ground

What does Volvo/Mack code MID 128 PID 110 FMI 4 mean?

The coolant temperature signal voltage is below the valid range, which the ECM reads as a short to ground at the sensor or in its wiring. The sensor value is replaced with a default. Urgency: check soon - the machine may derate or limit a function. Check first: read the live temperature; an unrealistically cold value on a hot engine confirms the fault.

FaultCheckMID 128PID 110FMI 4Volvo/Mack · MID 128 engine ECU - sensors and levels
MID 128
Which control unit reports it
PID 110
Parameter at fault
FMI 4
Voltage below normal or shorted low

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read the live temperature; an unrealistically cold value on a hot engine confirms the fault

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 5 done

Causes

  • Coolant temperature sensor shorted internally
  • Signal wire chafed to ground along the front of the engine
  • Water in the sensor connector bridging signal to ground

How it failed

You'll notice: The engine is hard to start in cold weather and idle regulation gets worse.

Shorted lowRead from FMI 4: voltage below normal or shorted low

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Coolant level and coolant temperature sensors

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 PID 110 FMI 4 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.