EF Logo

Volvo/Mack · MID 128 engine ECU - sensors and levels

Volvo/Mack Fault Code MID 128 PID 110 FMI 0

Engine coolant temperature critically high

What does Volvo/Mack code MID 128 PID 110 FMI 0 mean?

Coolant temperature reached the critical limit and the ECM is protecting the engine. This is a genuine overheat reading, so the cause is in the cooling system, not the sensor. Urgency: stop now - shut down and fix before working on. Check first: stop the engine and let it cool before opening anything; check coolant level and look for external leaks.

FaultStopMID 128PID 110FMI 0Volvo/Mack · MID 128 engine ECU - sensors and levels
MID 128
Which control unit reports it
PID 110
Parameter at fault
FMI 0
Data above normal, most severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Stop the engine and let it cool before opening anything; check coolant level and look for external leaks

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 5 done

Causes

  • Coolant level low from a leak or a failed cap
  • Thermostat stuck closed or only partly opening
  • Fan not engaging, or the fan clutch/drive not responding to the ECM
  • Radiator or charge air cooler blocked with debris or scale
1 more cause
  • Coolant pump worn so flow is low at high load

How it failed

You'll notice: Red stop lamp lights, the engine derates and the temperature gauge climbs toward the top.

Real conditionRead from FMI 0: data above normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Coolant level and coolant temperature sensors

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 PID 110 FMI 0 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.