Volvo/Mack · MID 128 engine ECU - sensors and levels
Volvo/Mack Fault Code MID 128 SID 33 FMI 3
Fan clutch output shorted high - fan runs full speed
What does Volvo/Mack code MID 128 SID 33 FMI 3 mean?
The engine fan clutch driver is shorted to positive. The ECM cannot control the fan and it stays engaged. Urgency: check soon - the machine may derate or limit a function. Check first: watch fan speed in the scan tool; it should vary with temperature.
- MID 128
- Which control unit reports it
- SID 33
- Component at fault
- FMI 3
- Voltage above normal or shorted high
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Watch fan speed in the scan tool; it should vary with temperature
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- Short to positive in the cooling fan control circuit
- Faulty cooling fan actuator
- Damaged harness or connector at the fan actuator
How it failed
You'll notice: The fan roars at full speed all the time, fuel consumption rises and a yellow check lamp is lit.
Shorted highRead from FMI 3: voltage above normal or shorted high
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Fan clutch control
- MID 128 SID 33 FMI 3Fan clutch output shorted high - fan runs full speedShorted highCheck soon
- MID 128 SID 33 FMI 4Fan clutch output shorted lowShorted lowCheck soon
- MID 128 SID 33 FMI 5Fan clutch output circuit openOpen circuitCheck soon
Other Volvo/Mack codes: MID 128 engine ECU - sensors and levels
- MID 128 PID 98 FMI 1Engine oil level critically low
- MID 128 PID 98 FMI 4Engine oil level sensor shorted to ground
- MID 128 PID 98 FMI 5Engine oil level sensor circuit open
- MID 128 PID 100 FMI 1Engine oil pressure critically low
- MID 128 PID 100 FMI 3Engine oil pressure sensor circuit shorted or ground open
- MID 128 PID 100 FMI 5Engine oil pressure sensor circuit open or shorted to ground
Related on Equipments Finder
Source
This source lists MID 128 SID 33 FMI 3 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
