EF Logo

Thermo King · Engine ECU faults (SR-2/SR-3/SR-4)

Thermo King Fault Code 608

Check rail pressure sensor

What does Thermo King code 608 mean?

The common rail fuel pressure sensor reading is out of range, so the ECU cannot regulate fuel pressure with confidence. Urgency: stop now - shut down and fix before working on. Check first: check the rail pressure sensor plug for water and corrosion.

FaultStop608Thermo King · Engine ECU faults (SR-2/SR-3/SR-4)

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Check the rail pressure sensor plug for water and corrosion

Then 4 more checks
Code shows hereFAULT608

Where this code shows

Press the alarm key or open the Alarms menu on the controller display to list active alarms.

Checks

0 of 5 done

Causes

  • Rail pressure sensor connector wet or corroded
  • Open or shorted sensor wire
  • Sensor failed
  • 5 V reference missing

How it failed

You'll notice: Alarm 608 and the engine may stall, run rough or limit to a low speed; hard starting is common.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine ECU rail pressure, injectors and EGR

Source

Thermo King Alarm Codes - North America (thermoking.com alarm code list)

This source lists 608 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Thermo King SR-2, SR-3, SR-4 truck and trailer units and related Thermo King controllers (the families the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.