EF Logo

Kubota · Loader controller (E:0xx)

Kubota Fault Code E:016

Auxiliary hydraulic control error (knob control switch)

What does Kubota code E:016 mean?

The knob or thumb control that proportionally operates the auxiliary hydraulics is sending a bad signal. The controller ignores the input until it gets a valid one. Urgency: check soon - the machine may derate or limit a function. Check first: wiggle the joystick harness and watch the signal in Diagmaster for dropouts.

FaultCheckE:016Kubota · Loader controller (E:0xx)

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Wiggle the joystick harness and watch the signal in Diagmaster for dropouts

Then 4 more checks
Code shows hereFAULTE:016

Where this code shows

Watch the meter panel: a warning lamp comes on and the E: code scrolls on the display.

Checks

0 of 5 done

Causes

  • Knob control switch contact worn or dirty
  • Open or shorted wire between the joystick knob and controller
  • Joystick connector corroded after pressure washing
  • Potentiometer inside the knob failed

How it failed

You'll notice: Auxiliary hydraulics will not respond, respond one way only or run uncontrolled, with E:016 on the meter.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Loader hydraulic controls and solenoids

Source

CodeReady - Kubota Skid Steer Loader Error Codes (SSV65, SSV75, SVL65-2, SVL75-3, SVL97-2), error code table

This source lists E:016 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Kubota SSV65, SSV75, SVL65-2, SVL75-3, SVL97-2 loaders (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.