EF Logo

Komatsu · Engine controller

Komatsu Fault Code CA2186

Throttle sensor power supply: low voltage

What does Komatsu code CA2186 mean?

The 5 V supply that powers the throttle (fuel dial) sensor is below its allowed range. The engine controller cannot trust the dial position, so engine speed may not follow the dial or may drop to idle. Urgency: check soon - the machine may derate or limit a function. Check first: unplug the throttle sensor and see whether the supply returns to about 5 V.

FaultCheckCA2186Komatsu · Engine controller

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Unplug the throttle sensor and see whether the supply returns to about 5 V

Then 3 more checks
Code shows hereFAULTCA2186

Where this code shows

Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.

Checks

0 of 4 done

Causes

  • Throttle sensor shorted and pulling the supply down
  • Throttle supply wire shorted to ground or rubbed through
  • Open supply wire or loose pin at the throttle connector

How it failed

You'll notice: Fuel dial does not control engine speed, with CA2186 on the monitor.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Throttle sensor and its supply

1 other code on this part is also shorted low (CA132). When they show together, start at the wiring and connector they share.

All 4 Throttle sensor and its supply codes on one page

Source

SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)

This source lists CA2186 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.