EF Logo

Komatsu · Engine controller

Komatsu Fault Code CA2185

Throttle sensor power supply: high voltage

What does Komatsu code CA2185 mean?

The 5 V supply that powers the throttle (fuel dial) sensor is above its allowed range. Urgency: check soon - the machine may derate or limit a function. Check first: unplug the throttle sensor and measure the supply wire to ground with key on; it should be about 5 V, not battery voltage.

FaultCheckCA2185Komatsu · Engine controller

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Unplug the throttle sensor and measure the supply wire to ground with key on; it should be about 5 V, not battery voltage

Then 3 more checks
Code shows hereFAULTCA2185

Where this code shows

Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.

Checks

0 of 4 done

Causes

  • Throttle supply wire touching a 12 V or 24 V line
  • Controller supply output fault feeding the throttle circuit
  • Water in the throttle sensor connector bridging the supply to another wire

How it failed

You'll notice: Fuel dial does not control engine speed, with CA2185 on the monitor.

Shorted highRead from how the source describes the code

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Throttle sensor and its supply

1 other code on this part is also shorted high (CA131). When they show together, start at the wiring and connector they share.

All 4 Throttle sensor and its supply codes on one page

Source

SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)

This source lists CA2185 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.