EF Logo

Komatsu · Engine controller

Komatsu Fault Code CA234

Engine overspeed

What does Komatsu code CA234 mean?

The engine speed went above the limit the controller allows. It is a protection event, usually caused by the engine running faster than the throttle asks, such as when travelling downhill or when something feeds extra fuel or oil. Urgency: stop now - shut down and fix before working on. Check first: ask the operator what the machine was doing when the code appeared, especially downhill travel or unloaded swings.

FaultStopCA234Komatsu · Engine controller

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Ask the operator what the machine was doing when the code appeared, especially downhill travel or unloaded swings

Then 5 more checks
Code shows hereFAULTCA234

Where this code shows

Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.

Checks

0 of 6 done

Causes

  • Machine driven downhill or over-run by the load with the engine speed high
  • Throttle dial or throttle sensor giving a wrong demand
  • Injector or rail pressure fault leaving the engine over-fuelled
  • Oil entering the intake, for example from the turbocharger or breather, feeding the engine
1 more cause
  • Controller reading a false speed from a damaged Ne sensor

How it failed

You'll notice: Engine speed warning with CA234 on the monitor; the SINOCMP table lists it as a mechanical-system failure with no user code.

Shorted highRead from how the source describes the code

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)

This source lists CA234 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.