Komatsu · Engine controller
Komatsu Fault Code CA322
Injector #1 (L#1) open or short circuit
What does Komatsu code CA322 mean?
The engine controller finds an open or shorted circuit on injector #1 (L#1). That cylinder can misfire or stop injecting, so the engine runs rough and loses power. Urgency: check soon - the machine may derate or limit a function. Check first: measure the coil resistance of injector #1 at its connector and compare it with the other five.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Measure the coil resistance of injector #1 at its connector and compare it with the other five
Then 4 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 5 done
Causes
- Connector at injector #1 under the valve cover loose or corroded
- Wire to injector #1 rubbed through at the cylinder head
- Open or shorted coil in injector #1
- Engine controller driver for cylinder 1 failed
How it failed
You'll notice: Engine runs on five cylinders, rough with less power, with CA322 on the monitor.
Lost messageRead from how the source describes the code
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Injector and IMV solenoid circuits
5 other codes on this part are also lost message (CA323, CA324, CA325, CA331 and more). When they show together, start at the wiring and connector they share.
- CA271IMV/PCV1 short circuitShort circuitCheck soon
- CA272IMV/PCV1 open circuitOpen circuitCheck soon
- CA322Injector #1 (L#1) open or short circuitLost messageCheck soon
- CA323Injector #5 (L#5) open or short circuitLost messageCheck soon
- CA324Injector #3 (L#3) open or short circuitLost messageCheck soon
- CA325Injector #6 (L#6) open or short circuitLost messageCheck soon
- CA331Injector #2 (L#2) open or short circuitLost messageCheck soon
- CA332Injector #4 (L#4) open or short circuitLost messageCheck soon
- CA342Calibration code not compatiblePart or controllerCheck soon
- CA351Injector drive circuit errorOtherCheck soon
- CA2311IMV solenoid current errorErratic or implausibleCheck soon
Other Komatsu codes: Engine controller
Related on Equipments Finder
Source
SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)
This source lists CA322 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
