EF Logo

John Deere · Main controller (MCZ) - temperature

John Deere Fault Code MCZ 11901.03

Hydraulic oil temperature sensor (B40) high

What does John Deere code MCZ 11901.03 mean?

The hydraulic oil temperature sensor (B40) signal is high (above 4.35 V). The machine may show a wrong oil temperature and skip warm-up logic. Urgency: check soon - the machine may derate or limit a function. Check first: unplug B40 and measure the harness signal pin voltage with the key on; near 5 V is what an open sensor gives.

FaultCheckMCZ11901.03John Deere · Main controller (MCZ) - temperature
MCZ
Which controller reports it
11901
What is at fault
.03
How it failed

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Unplug B40 and measure the harness signal pin voltage with the key on; near 5 V is what an open sensor gives

Then 4 more checks
Code shows hereFAULTMCZ11901.03

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 5 done

Causes

  • B40 signal wire open between the tank-side sensor and the MCZ, or the plug left unplugged after service
  • B40 thermistor failed open internally
  • B40 signal shorted to the 5 V sensor supply in the harness
  • Corroded B40 connector terminals adding resistance in the signal path

How it failed

You'll notice: The primary hydraulic oil temperature sensor (B40) reads as a very cold or open sensor.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Pump pressure and hydraulic oil temperature sensors

Show the other 9 codes
All 18 Pump pressure and hydraulic oil temperature sensors codes on one page

Source

Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)

This source lists MCZ 11901.03 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.