EF Logo

John Deere · Main controller (MCZ) - pressure sensors

John Deere Fault Code MCZ 11200.04

Pump 1 delivery pressure sensor (B35) signal low

What does John Deere code MCZ 11200.04 mean?

The main controller reads the pump 1 delivery pressure sensor (B35) on the pump 1 delivery line as low (below 0.1 V). Urgency: check soon - the machine may derate or limit a function. Check first: check for 5 V between the supply and ground pins of the unplugged B35 connector with the key on; none means look back toward the MCZ supply wire.

FaultCheckMCZ11200.04John Deere · Main controller (MCZ) - pressure sensors
MCZ
Which controller reports it
11200
What is at fault
.04
How it failed

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check for 5 V between the supply and ground pins of the unplugged B35 connector with the key on; none means look back toward the MCZ supply wire

Then 4 more checks
Code shows hereFAULTMCZ11200.04

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 5 done

Causes

  • Signal wire from B35 broken inside the sleeve or chafed through at a harness clamp
  • B35 signal wire shorted to the frame near the pump 1 delivery line
  • No 5 V at B35 because of a broken supply wire or a pin pushed back in the plug
  • B35 failed low, outputting close to 0 V at any pressure

How it failed

You'll notice: Pump 1 delivery pressure shows zero to the MCZ, so the controller has no pump 1 load signal and falls back to a safe pump setting.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Pump pressure and hydraulic oil temperature sensors

Show the other 9 codes
All 18 Pump pressure and hydraulic oil temperature sensors codes on one page

Source

Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)

This source lists MCZ 11200.04 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.