EF Logo

John Deere · Main controller (MCZ) - pressure sensors

John Deere Fault Code MCZ 11202.03

Pump 2 delivery pressure sensor (B37) signal high

What does John Deere code MCZ 11202.03 mean?

The main controller reads the pump 2 delivery pressure sensor (B37) on the pump 2 delivery line as high. Urgency: check soon - the machine may derate or limit a function. Check first: with B37 unplugged and key on, measure its harness signal pin; supply-level voltage proves a wiring or MCZ fault and not the sensor.

FaultCheckMCZ11202.03John Deere · Main controller (MCZ) - pressure sensors
MCZ
Which controller reports it
11202
What is at fault
.03
How it failed

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

With B37 unplugged and key on, measure its harness signal pin; supply-level voltage proves a wiring or MCZ fault and not the sensor

Then 4 more checks
Code shows hereFAULTMCZ11202.03

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 5 done

Causes

  • Short to the 5 V feed in the B37 pigtail, often where it is tie-wrapped against hot or moving parts
  • B37 sensing element gone high, giving full scale whatever pump 2 pressure is
  • Sensor ground wire open, so B37 has no return path and its signal rises
  • Dirty or wet B37 plug leaking between the supply and signal pins

How it failed

You'll notice: The MCZ sees pump 2 stuck at maximum delivery pressure and cuts pump 2 flow to compensate.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Pump pressure and hydraulic oil temperature sensors

Show the other 9 codes
All 18 Pump pressure and hydraulic oil temperature sensors codes on one page

Source

Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)

This source lists MCZ 11202.03 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.