EF Logo

JLG · Platform / ground controls

JLG Fault Code 2‑5

Function prevented by cutout

What does JLG code 2-5 mean?

Not a failure. The controller blocks a function on purpose because a cutout is set: drive while elevated, boom while driving, or drive while tilted and above elevation. Urgency: information - a reminder or status message. Check first: read the Help message: DRIVE PREVENTED or BOOM PREVENTED.

FaultInfo2-5JLG · Platform / ground controls

Can I keep running with it?

Information

A reminder or status message. Nothing is failing yet.

What should I check first?

Read the Help message: DRIVE PREVENTED or BOOM PREVENTED

Then 3 more checks
Code shows hereFAULT2-5

Where this code shows

Turn the key on and watch the fault lamp or platform display.

Checks

0 of 4 done

Causes

  • Drive selected while the boom is above elevation with drive cutout configured
  • Boom function selected while driving with the no-simultaneous-drive cutout active
  • Chassis tilted past the set angle while above elevation
  • Function cutout configuration digit set for CE or a special market

How it failed

You'll notice: A function refuses to move on purpose and the lamp shows 2-5.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Cutouts, reduced speed, overload and status messages

Source

JLG 600S/600SJ/660SJ/600A/AJ Service and Maintenance Manual 3120840, section 6 (Tables 6-3, 6-5)

This source lists 2-5 and its meaning. The guidance on this page is general, not taken from it.

The source covers: JLG boom lifts with the JLG Control System (600S, 600SJ, 660SJ, 600A/AJ, 450A, 510A, 400S, 1200/1350SJP families).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.