EF Logo

JLG · Status

JLG Fault Code 0010

Running at cutback - out of transport position

What does JLG code 0010 mean?

Not a fault. The machine is running at cutback because the boom is out of its transport (stowed) position, so drive and function speeds are reduced. Urgency: information - a reminder or status message. Check first: lower and retract the boom fully to the stowed position and see whether the message clears.

FaultInfo0010JLG · Status

Can I keep running with it?

Information

A reminder or status message. Nothing is failing yet.

What should I check first?

Lower and retract the boom fully to the stowed position and see whether the message clears

Then 4 more checks
Code shows hereFAULT0010

Where this code shows

Turn the key on and watch the fault lamp or platform display.

Checks

0 of 5 done

Causes

  • Boom raised or extended past the stowed position, which is normal operation
  • Transport or elevation switch not reading stowed when the boom is actually stowed
  • Proximity sensor or switch target out of gap after a knock
  • Transport switch harness damaged or connector loose
1 more cause
  • Cutback configured for the market or model

How it failed

You'll notice: The machine runs slower than normal with the boom raised or extended, as it is meant to.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Cutouts, reduced speed, overload and status messages

Source

JLG 600S/660SJ Service and Maintenance Manual 3121298, section 6 (Table 6-8 Fault Code List)

This source lists 0010 and its meaning. The guidance on this page is general, not taken from it.

The source covers: JLG 600S, 600SJ, 660SJ with newer module software; same DTC scheme on other JLG Control System booms, confirm in your manual.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.