EF Logo

JLG · Platform / ground controls

JLG Fault Code 213

Footswitch faulty

What does JLG code 213 mean?

The two footswitch signals have been in the same state for too long, so the controller judges the footswitch faulty. Platform functions are locked out and the EMS must be recycled to clear the fault. Urgency: check soon - the machine may derate or limit a function. Check first: watch both footswitch inputs in the analyzer diagnostics; they should switch in opposite states as the pedal is pressed and released.

FaultCheck213JLG · Platform / ground controls

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Watch both footswitch inputs in the analyzer diagnostics; they should switch in opposite states as the pedal is pressed and released

Then 4 more checks
Code shows hereFAULT213

Where this code shows

Turn the key on and watch the fault lamp or platform display.

Checks

0 of 5 done

Causes

  • Footswitch contact stuck or worn so both signals match
  • Footswitch cable pinched or broken inside the platform box
  • Platform module connector corroded at the footswitch pins
  • Water in the platform control box
1 more cause
  • Platform module input fault

How it failed

You'll notice: The footswitch is judged faulty and every platform function is locked out until EMS is recycled.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Footswitch, joysticks, steer switches and start sequence

Show the other 17 codes
All 26 Footswitch, joysticks, steer switches and start sequence codes on one page

Source

JLG 600S/660SJ Service and Maintenance Manual 3121298, section 6 (Table 6-8 Fault Code List)

This source lists 213 and its meaning. The guidance on this page is general, not taken from it.

The source covers: JLG 600S, 600SJ, 660SJ with newer module software; same DTC scheme on other JLG Control System booms, confirm in your manual.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.