EF Logo

JLG · Platform / ground controls

JLG Fault Code 2‑2

Drive or steer selection fault

What does JLG code 2-2 mean?

The drive or steer inputs are in a state the controller will not accept: joystick moved before the footswitch, steer selected before the footswitch, both steer switches active, or the joystick signal out of range. Urgency: check soon - the machine may derate or limit a function. Check first: release everything, let the footswitch open, then press the footswitch first and select drive after.

FaultCheck2-2JLG · Platform / ground controls

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Release everything, let the footswitch open, then press the footswitch first and select drive after

Then 4 more checks
Code shows hereFAULT2-2

Where this code shows

Turn the key on and watch the fault lamp or platform display.

Checks

0 of 5 done

Causes

  • Operator moved the drive joystick or steer switch before pressing the footswitch
  • Footswitch held closed about 7 seconds with nothing selected
  • Drive joystick centre tap voltage outside its window (resistive about 3.08-3.83 V, inductive about 2.18-2.70 V)
  • Q-Prox sensor on an inductive joystick reading above about 3.18 V, or joystick not neutral
1 more cause
  • Steer rocker switches stuck or wiring shorted

How it failed

You'll notice: Drive and steer do not respond from the platform even though the engine runs.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Footswitch, joysticks, steer switches and start sequence

Show the other 17 codes
All 26 Footswitch, joysticks, steer switches and start sequence codes on one page

Source

JLG 600S/600SJ/660SJ/600A/AJ Service and Maintenance Manual 3120840, section 6 (Tables 6-3, 6-5)

This source lists 2-2 and its meaning. The guidance on this page is general, not taken from it.

The source covers: JLG boom lifts with the JLG Control System (600S, 600SJ, 660SJ, 600A/AJ, 450A, 510A, 400S, 1200/1350SJP families).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.