JLG · Platform / ground controls
JLG Fault Code 212
Keyswitch faulty
What does JLG code 212 mean?
The keyswitch inputs are not valid: both ground and platform positions are active together, or neither is. Platform and ground functions are blocked until the controller sees one clear position. Urgency: check soon - the machine may derate or limit a function. Check first: read the analyzer Help message and see which key position the controller thinks is selected.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Read the analyzer Help message and see which key position the controller thinks is selected
Then 4 more checksWhere this code shows
Turn the key on and watch the fault lamp or platform display.
Checks
0 of 5 done
Causes
- Keyswitch contacts worn or stuck between positions
- Keyswitch wires shorted together or open at the ground station
- Corroded connector at the ground module key input
- Ground module key input fault (rare)
How it failed
You'll notice: Neither or both keyswitch positions read active, so the platform and ground controls are both locked out.
Real conditionRead from how the source describes the code
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other JLG codes: Platform / ground controls
- 2-1Footswitch or keyswitch fault
- 213Footswitch faulty
- 224Function problem - steer left permanently selected
- 225Function problem - steer right permanently selected
- 227Steer switches faulty
- 234Function switches faulty - check diagnostics/boom
- 235Function switches locked - selected before aux power
- 236Function switches locked - selected before start switch
Related on Equipments Finder
Source
JLG 600S/660SJ Service and Maintenance Manual 3121298, section 6 (Table 6-8 Fault Code List)
This source lists 212 and its meaning. The guidance on this page is general, not taken from it.
The source covers: JLG 600S, 600SJ, 660SJ with newer module software; same DTC scheme on other JLG Control System booms, confirm in your manual.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
