EF Logo

Deutz · ECU power and supply

Deutz Fault Code SPN 168 FMI 4

Machine - Battery voltage - Voltage below normal or shorted to low source

What does Deutz code SPN 168 FMI 4 mean?

The EMR4 measures the machine battery voltage (at the EMR4 supply connector, fed from the machine battery and ignition) below range or shorted to ground; the voltage at the EMR4 supply pin is too low. Urgency: check soon - the machine may derate or limit a function. Check first: check the main ground between engine block, frame and battery negative.

FaultCheckSPN 168FMI 4Deutz · ECU power and supply
FMI 4
Voltage below normal or shorted low

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the main ground between engine block, frame and battery negative

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Read the active and stored faults with Deutz SerDia (or the machine maker's diagnostic tool) on the engine diagnostic plug.

Checks

0 of 4 done

Causes

  • Alternator regulator failing and over- or undercharging
  • Corroded battery terminal or ground strap
  • High-resistance connection in the ignition or power feed to the EMR4
  • Undervoltage points at a weak battery, high resistance in a power feed, or the alternator not charging

How it failed

You'll notice: Expect a warning lamp; you see a warning lamp, hard starting, or ECU resets, because the EMR4 needs a stable supply to drive the injectors.

Shorted lowRead from FMI 4: voltage below normal or shorted low

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: EMR4 controller, memory, supply and immobilizer

1 other code on this part is also shorted low (SPN 523612 FMI 4). When they show together, start at the wiring and connector they share.

Show the other 16 codes
All 25 EMR4 controller, memory, supply and immobilizer codes on one page

Source

DEUTZ KWP-Codes EMR4 (KWPList EMR4 DE EN, Revision 2.0), page 1

This source lists SPN 168 FMI 4 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Deutz engines with the EMR4 controller (the Deutz list applies to all EMR4 engine series, e.g. TCD 2.9, 3.6, 4.1, 6.1, 7.8 as fitted in machines).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.