J1939 · Electrical
SPN 168 Fault Code
Battery potential / power input 1
What does SPN 168 mean?
Battery voltage at the ECM's power input. The ECM monitors it so a weak battery, poor ground or bad charging does not upset sensors and injector drivers. How urgent it is depends on the FMI after SPN 168 - pick it below. Check first: measure battery voltage at the terminals and at the ECM connector with the engine off and running.
- SPN 168
- Battery potential / power input 1
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 168 - pick it below.
What should I check first?
Measure battery voltage at the terminals and at the ECM connector with the engine off and running
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 168?
You'll notice: Battery voltage at the ECM is too high or too low, so electronics may misbehave.
Find the number shown after SPN 168 on your display. 2 of them have their own page with causes and checks.
- 0SPN 168 FMI 0: Battery voltage at the ECM is too highReal conditionDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
- 1SPN 168 FMI 1: Battery voltage at the ECM is too low or the power input is openReal conditionDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 1 more
- 2SPN 168 FMI 2: Ignition circuit voltage is erraticErratic or implausibleDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
- 4SPN 168 FMI 4: ECU power supply voltage is too lowShorted lowPACCAR MX-13
- 5SPN 168 FMI 5: Battery voltage input is open circuit at the ECMOpen circuitDetroit DD15, Detroit DD13
- 7SPN 168 FMI 7: Optimized idle detected a charging system or battery failurePart or controllerDetroit DD15, Detroit DD13
- 9SPN 168 FMI 9: The ECM has lost its battery connectionLost messageDetroit DD15, Detroit DD13
- 14SPN 168 FMI 14: Optimized idle flagged a charging or battery failure, or the ECU did not power down properlyOtherDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
- 15SPN 168 FMI 15: Value is above the normal range, least severe levelReal conditionCummins ISX15
- 16SPN 168 FMI 16: Value is above the normal range, moderately severe levelReal conditionCummins ISX15
- 17SPN 168 FMI 17: Value is below the normal range, least severe levelReal conditionCummins ISX15
- 18SPN 168 FMI 18: Value is below the normal range, moderately severe levelReal conditionCummins ISX15
- 19SPN 168 FMI 19: A message carrying the aftertreatment power supply value arrived in error over CANLost messagePACCAR MX-13
Checks
0 of 5 done
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
How urgent SPN 168 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Low voltage: weak or discharged batteries, a loose terminal or a corroded ground strap
- Charging fault: alternator not charging or overcharging from a failed regulator
- High resistance in the ECM power feed or ground, giving low voltage at the ECM only
- Jump-start or wrong battery connection raising or reversing the voltage
Other Electrical codes
- SPN 524Transmission message (ETC2) missing
- SPN 627Injector power supply
- SPN 629Engine control module internal failure
- SPN 639J1939 data link
- SPN 677Starter relay driver circuit
- SPN 1136ECU internal temperature
- SPN 3597ECU power output supply voltage / power lost with key on
- SPN 158Ignition switch / keyswitch voltage
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 168 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
