J1939 · Electrical
SPN 158 Fault Code
Keyswitch battery potential
What does SPN 158 mean?
Voltage at the ECM's ignition (keyswitch) input. The ECM uses it to know when the key is on and to detect wiring or relay problems. How urgent it is depends on the FMI after SPN 158 - pick it below. Check first: measure the ignition voltage at the ECM connector with the key on.
- SPN 158
- Keyswitch battery potential
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 158 - pick it below.
What should I check first?
Measure the ignition voltage at the ECM connector with the key on
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 158?
You'll notice: The ignition (keyswitch) power seen by the ECM is wrong, so the ECM may not wake or may drop out.
Find the number shown after SPN 158 on your display.
- 0SPN 158 FMI 0: Value is above the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
- 1SPN 158 FMI 1: Value is below the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
- 2SPN 158 FMI 2: Ignition switch signal is implausible or disagrees between modulesErratic or implausibleDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
- 3SPN 158 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highMack MP8, Mack MP7, Volvo D13
- 4SPN 158 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowMack MP8, Mack MP7, Volvo D13
- 16SPN 158 FMI 16: Value is above the normal range, moderately severe levelReal conditionMack MP8, Mack MP7, Volvo D13
- 18SPN 158 FMI 18: Value is below the normal range, moderately severe levelReal conditionMack MP8, Mack MP7, Volvo D13
Checks
0 of 5 done
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
How urgent SPN 158 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Keyswitch or ignition relay worn, giving a poor contact
- Wiring fault: voltage drop, loose terminal or corrosion on the ignition feed
- Blown fuse or failed relay on the ECM supply
- Battery voltage low, so the ignition signal is also low
Other Electrical codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list names SPN 158 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Detroit DD13 and DD15 (2017-2020); same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
