Volvo/Mack · MID 144 vehicle ECU
Volvo/Mack Fault Code MID 144 SID 253 FMI 2
VECU calibration memory (EEPROM) checksum error
What does Volvo/Mack code MID 144 SID 253 FMI 2 mean?
The data sets stored in the VECU calibration memory (EEPROM) have an incorrect checksum, so some saved parameters are damaged. Urgency: check soon - the machine may derate or limit a function. Check first: reprogram the VECU parameters with the Premium Tech Tool.
- MID 144
- Which control unit reports it
- SID 253
- Component at fault
- FMI 2
- Erratic or incorrect data
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Reprogram the VECU parameters with the Premium Tech Tool
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- Faulty EEPROM inside the VECU
- VECU failure
- Interrupted parameter programming
How it failed
You'll notice: Yellow lamp lit and some functions may be deactivated until the parameters are restored.
Erratic or implausibleRead from FMI 2: erratic or incorrect data
The reading jumps, drifts or disagrees with the sensors around it.
- Meter test
- Watch the live value on the service tool while you flex the harness and tap the connector.
- Good result
- A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 144 vehicle ECU
- MID 144 SID 240 FMI 2VECU program memory checksum error
- MID 144 PSID 2 FMI 7Idle validation switch 2 reads wrong
- MID 144 PSID 25 FMI 14Air leakage - flow too high
- MID 144 PPID 72 FMI 3Pedal and engine brake sensor supply too high
- MID 144 PPID 72 FMI 4Pedal and engine brake sensor supply too low
- MID 144 PID 84 FMI 2Vehicle speed signal incorrect or intermittent
- MID 144 PID 84 FMI 5Vehicle speed sensor open circuit or shorted to ground
- MID 144 PID 84 FMI 6Vehicle speed sensor current high or shorted across sensor
Related on Equipments Finder
Source
This source lists MID 144 SID 253 FMI 2 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
