EF Logo

Volvo/Mack · MID 144 vehicle ECU

Volvo/Mack Fault Code MID 144 SID 243 FMI 7

Cruise control set switch - SET+ and SET- at the same time

What does Volvo/Mack code MID 144 SID 243 FMI 7 mean?

The VECU receives the SET+ and SET- signals at the same time, which cannot happen on a good switch. Urgency: check soon - the machine may derate or limit a function. Check first: check the steering column switch connector for damage, corrosion or looseness.

FaultCheckMID 144SID 243FMI 7Volvo/Mack · MID 144 vehicle ECU
MID 144
Which control unit reports it
SID 243
Component at fault
FMI 7
Mechanical system not responding

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the steering column switch connector for damage, corrosion or looseness

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Faulty harness between the switch and the VECU
  • Faulty connector at the steering column
  • Faulty cruise control switch

How it failed

You'll notice: Yellow lamp lit and cruise control is deactivated until the SET switch fault is cleared.

Part or controllerRead from FMI 7: mechanical system not responding

The controller reports a part, module or its software as faulty or not responding.

ControllerPartSupplySignalGround?
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Check power and ground at the module connector with the key on, then its fuses.
Good result
Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Group 36 Vehicle Electronic Control Unit (MID 144) Diagnostic Trouble Code Guide, PV776-88951780

This source lists MID 144 SID 243 FMI 7 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.