Volvo/Mack · MID 144 vehicle ECU
Volvo/Mack Fault Code MID 144 SID 231 FMI 2
SAE J1939 data link intermittent or not acknowledged
What does Volvo/Mack code MID 144 SID 231 FMI 2 mean?
The VECU does not get an acknowledgement on the messages it sends over the J1939 data link. The CAN bus is down, shorted or only partly working. Urgency: check soon - the machine may derate or limit a function. Check first: measure resistance across the CAN high and low pins at the diagnostic connector with the key off.
- MID 144
- Which control unit reports it
- SID 231
- Component at fault
- FMI 2
- Erratic or incorrect data
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Measure resistance across the CAN high and low pins at the diagnostic connector with the key off
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- J1939 data link down or shorted
- CAN communication fault from another module pulling the bus down
- Damaged data link connector
How it failed
You'll notice: Yellow lamp lit and CAN communication fails, which can take out cluster gauges, cruise, PTO and engine controls.
Erratic or implausibleRead from FMI 2: erratic or incorrect data
The reading jumps, drifts or disagrees with the sensors around it.
- Meter test
- Watch the live value on the service tool while you flex the harness and tap the connector.
- Good result
- A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 144 vehicle ECU
- MID 144 SID 250 FMI 2SAE J1587 data link faulty messages
- MID 144 PSID 200 FMI 9Data link lost - engine control module (ECM)
- MID 144 SID 240 FMI 2VECU program memory checksum error
- MID 144 SID 243 FMI 7Cruise control set switch - SET+ and SET- at the same time
- MID 144 SID 253 FMI 2VECU calibration memory (EEPROM) checksum error
- MID 144 PPID 265 FMI 3Vehicle speed sensor supply too high
- MID 144 PPID 265 FMI 4Vehicle speed sensor supply too low
- MID 144 PPID 312 FMI 0Air dryer regeneration air flow too high
Related on Equipments Finder
Source
This source lists MID 144 SID 231 FMI 2 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack and Volvo trucks with the MID 144 vehicle ECU (VECU), built from 2007; guide written for Mack, same VECU family as Volvo VN/VNL.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
