EF Logo

Volvo/Mack · MID 128 engine ECU - air, turbo, EGR and brake

Volvo/Mack Fault Code MID 128 SID 146 FMI 3

EGR valve control shorted high or stuck

What does Volvo/Mack code MID 128 SID 146 FMI 3 mean?

The EGR valve control circuit is shorted to positive or to ground, or the valve is stuck. The ECM cannot position the EGR valve. Urgency: check soon - the machine may derate or limit a function. Check first: command the EGR valve in the scan tool and see whether it moves and reports position.

FaultCheckMID 128SID 146FMI 3Volvo/Mack · MID 128 engine ECU - air, turbo, EGR and brake
MID 128
Which control unit reports it
SID 146
Component at fault
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Command the EGR valve in the scan tool and see whether it moves and reports position

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • EGR valve stuck from soot
  • EGR valve circuit shorted to positive or ground
  • Damaged harness or connector
  • Faulty EGR valve actuator

How it failed

You'll notice: MIL lamp on and the engine derates because the ECM limits power when it cannot control EGR.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: EGR valve control

All 2 EGR valve control codes on one page

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 SID 146 FMI 3 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.