EF Logo

Volvo/Mack · MID 128 engine ECU - aftertreatment (DPF, DEF, NOx)

Volvo/Mack Fault Code MID 128 PPID 337 FMI 0

DPF ash level too high

What does Volvo/Mack code MID 128 PPID 337 FMI 0 mean?

The DPF ash load is above the limit. Mack says the filter needs service because the ash level is too high. Urgency: information - a reminder or status message. Check first: check the DPF ash level in the scan tool for damage, corrosion or looseness.

FaultInfoMID 128PPID 337FMI 0Volvo/Mack · MID 128 engine ECU - aftertreatment (DPF, DEF, NOx)
MID 128
Which control unit reports it
PPID 337
Maker parameter at fault
FMI 0
Data above normal, most severe

Can I keep running with it?

Information

A reminder or status message. Nothing is failing yet.

What should I check first?

Check the DPF ash level in the scan tool for damage, corrosion or looseness

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • DPF ash load beyond the service limit from normal use
  • High oil consumption adding ash to the filter faster than normal
  • Filter cleaning interval overdue

How it failed

You'll notice: Yellow check lamp lit; regenerations get closer together until the filter is cleaned.

Real conditionRead from FMI 0: data above normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 PPID 337 FMI 0 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.