EF Logo

Volvo/Mack · MID 128 engine ECU - aftertreatment (DPF, DEF, NOx)

Volvo/Mack Fault Code MID 128 PID 81 FMI 0

DPF differential pressure critically high

What does Volvo/Mack code MID 128 PID 81 FMI 0 mean?

The pressure drop across the diesel particulate filter is critically high. The filter is badly loaded or blocked, or the pressure sensor is reading wrongly. Urgency: stop now - shut down and fix before working on. Check first: read DPF differential pressure at idle and at high idle and compare with the soot load estimate.

FaultStopMID 128PID 81FMI 0Volvo/Mack · MID 128 engine ECU - aftertreatment (DPF, DEF, NOx)
MID 128
Which control unit reports it
PID 81
Parameter at fault
FMI 0
Data above normal, most severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Read DPF differential pressure at idle and at high idle and compare with the soot load estimate

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 5 done

Causes

  • DPF blocked with soot or ash
  • DPF differential pressure sensor failed
  • Differential pressure hoses blocked or swapped

How it failed

You'll notice: Red stop lamp lit and the engine derates heavily.

Real conditionRead from FMI 0: data above normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: EGR flow and DPF filter pressure drop

2 other codes on this part are also real condition (MID 128 PID 411 FMI 0, MID 128 PID 411 FMI 1). When they show together, start at the wiring and connector they share.

All 5 EGR flow and DPF filter pressure drop codes on one page

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 PID 81 FMI 0 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.