Thermo King · Engine ECU faults (SR-2/SR-3/SR-4)
Thermo King Fault Code 608
Check rail pressure sensor
What does Thermo King code 608 mean?
The common rail fuel pressure sensor reading is out of range, so the ECU cannot regulate fuel pressure with confidence. Urgency: stop now - shut down and fix before working on. Check first: check the rail pressure sensor plug for water and corrosion.
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Check the rail pressure sensor plug for water and corrosion
Then 4 more checksWhere this code shows
Press the alarm key or open the Alarms menu on the controller display to list active alarms.
Checks
0 of 5 done
Causes
- Rail pressure sensor connector wet or corroded
- Open or shorted sensor wire
- Sensor failed
- 5 V reference missing
How it failed
You'll notice: Alarm 608 and the engine may stall, run rough or limit to a low speed; hard starting is common.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Engine ECU rail pressure, injectors and EGR
- 163Emission control failureOtherCheck soon
- 608Check rail pressure sensorOtherStop now
- 613Check injectorsOtherStop now
- 614High pressure fuel pump checkReal conditionInformation
- 615Rail pressure faultReal conditionStop now
- 618Check EGR systemOtherCheck soon
- 624EGR temperature sensor checkOtherInformation
- 808Rail pressure sensor errorErratic or implausibleInformation
- 813General injector errorOtherInformation
Show the other 7 codesHide the other codes
- 815Fuel pressure regulator errorOtherCheck soon
- 818EGR valve actuator errorOtherInformation
- 827EGR valve position sensor errorOtherInformation
- 833High pressure pump fuel metering unit errorReal conditionInformation
- 840Fuel injection energizing errorOtherInformation
- 841High pressure pump wearReal conditionInformation
- 843Fuel injection system errorOtherInformation
Other Thermo King codes: Engine ECU faults (SR-2/SR-3/SR-4)
Source
Thermo King Alarm Codes - North America (thermoking.com alarm code list)
This source lists 608 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Thermo King SR-2, SR-3, SR-4 truck and trailer units and related Thermo King controllers (the families the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
