EF Logo

Kubota · Loader controller (E:0xx)

Kubota Fault Code E:009

Acceleration system error

What does Kubota code E:009 mean?

The throttle command path (accelerator dial or pedal sensor and its signal to the engine ECU) is out of range or channels disagree. Engine speed control can be limited as a result. Urgency: check soon - the machine may derate or limit a function. Check first: sweep the dial or pedal with key on while reading its value in Diagmaster and look for jumps or dead zones.

FaultCheckE:009Kubota · Loader controller (E:0xx)

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Sweep the dial or pedal with key on while reading its value in Diagmaster and look for jumps or dead zones

Then 4 more checks
Code shows hereFAULTE:009

Where this code shows

Watch the meter panel: a warning lamp comes on and the E: code scrolls on the display.

Checks

0 of 5 done

Causes

  • Accelerator sensor signal out of range
  • Broken or shorted signal wire to the engine ECU
  • Connector at the engine ECU not fully seated
  • 5 V sensor supply pulled down by a shorted sensor

How it failed

You'll notice: Engine speed will not follow the dial or pedal, sticks at idle or high idle, and E:009 shows on the meter.

Lost messageRead from how the source describes the code

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Loader controller supply, drive and fan

Source

CodeReady - Kubota Skid Steer Loader Error Codes (SSV65, SSV75, SVL65-2, SVL75-3, SVL97-2), error code table

This source lists E:009 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Kubota SSV65, SSV75, SVL65-2, SVL75-3, SVL97-2 loaders (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.