Kubota · Loader controller (E:0xx)
Kubota Fault Code E:008
Fuel sensor system error
What does Kubota code E:008 mean?
The controller sees an abnormal signal from the fuel level sensor circuit. The fuel gauge cannot be trusted while the code is active, so fuel level has to be checked by eye. Urgency: check soon - the machine may derate or limit a function. Check first: look in the tank and note the real fuel level against what the gauge shows.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Look in the tank and note the real fuel level against what the gauge shows
Then 4 more checksWhere this code shows
Watch the meter panel: a warning lamp comes on and the E: code scrolls on the display.
Checks
0 of 5 done
Causes
- Fuel level sender float arm stuck or resistance track worn
- Open or shorted sender wire between tank and meter
- Corroded sender connector at the top of the tank
- Poor ground at the sender mounting
How it failed
You'll notice: Fuel gauge reads empty, stuck or jumps around and E:008 appears; the engine keeps running normally.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Loader controller supply, drive and fan
- E:001CAN communication errorLost messageCheck soon
- E:008Fuel sensor system errorOtherCheck soon
- E:009Acceleration system errorLost messageCheck soon
- E:011Parking brake system errorLost messageStop now
- E:020Electronic travel torque management system errorOtherCheck soon
- E:021Sensor 5 V power supply short-circuitedLost messageCheck soon
- E:022Fan rpm control solenoid valve cable brokenOpen circuitCheck soon
- E:023Jump start with a 24 V battery or improper deviceLost messageStop now
- E:026CRS CAN communication errorLost messageCheck soon
- E:028Fan solenoid broken or short-circuitedLost messageCheck soon
Other Kubota codes: Loader controller (E:0xx)
Related on Equipments Finder
Source
This source lists E:008 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Kubota SSV65, SSV75, SVL65-2, SVL75-3, SVL97-2 loaders (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
