Kubota · Loader controller (E:0xx)
Kubota Fault Code E:001
CAN communication error
What does Kubota code E:001 mean?
The loader's main controller and another unit on the CAN bus (meter panel, engine ECU or valve controller) stopped exchanging data. Urgency: check soon - the machine may derate or limit a function. Check first: key off and measure resistance across CAN-H and CAN-L at the diagnostic connector; a healthy bus with two terminators reads about 60 ohms.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Key off and measure resistance across CAN-H and CAN-L at the diagnostic connector; a healthy bus with two terminators reads about 60 ohms
Then 4 more checksWhere this code shows
Watch the meter panel: a warning lamp comes on and the E: code scrolls on the display.
Checks
0 of 5 done
Causes
- Chafed or broken CAN-H / CAN-L twisted pair in the main harness
- Water or corrosion inside a controller connector
- Terminating resistor at one end of the bus missing or open
- Weak battery resetting a controller during cranking
How it failed
You'll notice: Warning lamp and E:001 on the meter; some functions such as travel speed, auxiliary flow or gauges may act oddly.
Lost messageRead from how the source describes the code
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Loader controller supply, drive and fan
6 other codes on this part are also lost message (E:009, E:011, E:021, E:023 and more). When they show together, start at the wiring and connector they share.
- E:001CAN communication errorLost messageCheck soon
- E:008Fuel sensor system errorOtherCheck soon
- E:009Acceleration system errorLost messageCheck soon
- E:011Parking brake system errorLost messageStop now
- E:020Electronic travel torque management system errorOtherCheck soon
- E:021Sensor 5 V power supply short-circuitedLost messageCheck soon
- E:022Fan rpm control solenoid valve cable brokenOpen circuitCheck soon
- E:023Jump start with a 24 V battery or improper deviceLost messageStop now
- E:026CRS CAN communication errorLost messageCheck soon
- E:028Fan solenoid broken or short-circuitedLost messageCheck soon
Other Kubota codes: Loader controller (E:0xx)
Related on Equipments Finder
Source
This source lists E:001 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Kubota SSV65, SSV75, SVL65-2, SVL75-3, SVL97-2 loaders (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
