Komatsu · Monitor user codes
Komatsu Fault Code E02
PC-EPC system
What does Komatsu code E02 mean?
User code E02 means a fault in the PC-EPC system that sets the pump output. The failure codes behind it are the PC-EPC solenoid circuits DXA8KA/KB and DXA9KA/KB. Urgency: check soon - the machine may derate or limit a function. Check first: read the failure codes in service mode and note which PC-EPC code is active.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Read the failure codes in service mode and note which PC-EPC code is active
Then 3 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 4 done
Causes
- PC-EPC solenoid coil open or shorted
- Wire to the PC-EPC solenoid damaged
- Pump controller output failed
How it failed
You'll notice: Caution or E02 on the monitor with weak or slow hydraulics.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Operator user codes (E02, E03, E05, E10 and similar)
- E0ENetwork (data link) failureLost messageCheck soon
- E02PC-EPC systemOtherCheck soon
- E03Swing parking brake systemOtherCheck soon
- E05Governor motor systemOtherCheck soon
- E10Engine controller power or drive failureOtherCheck soon
- E11Engine control system failure, output limitedOtherCheck soon
- E14Feedback system failure (throttle circuit)OtherCheck soon
- E15Engine sensor failureOtherCheck soon
Other Komatsu codes: Monitor user codes
Related on Equipments Finder
Source
Komatsu Fault Codes List (SlideShare, PC200-8 user and failure codes)
This source lists E02 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
