EF Logo

Komatsu · Monitor user codes

Komatsu Fault Code E0E

Network (data link) failure

What does Komatsu code E0E mean?

User code E0E points to a failure on the machine data link. The controllers can no longer exchange data, so the monitor may lose engine or pump information and some functions may drop out. Urgency: check soon - the machine may derate or limit a function. Check first: read DA2RMC or CA1633 in service mode to see which controller is missing.

FaultCheckE0EKomatsu · Monitor user codes

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read DA2RMC or CA1633 in service mode to see which controller is missing

Then 3 more checks
Code shows hereFAULTE0E

Where this code shows

Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.

Checks

0 of 4 done

Causes

  • CAN or KOMNET data link wire open or shorted
  • Pump or engine controller without power or ground
  • Loose controller connector
  • Controller left on the wrong software after replacement

How it failed

You'll notice: Network failure on the monitor with E0E.

Lost messageRead from how the source describes the code

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Operator user codes (E02, E03, E05, E10 and similar)

Source

SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)

This source lists E0E and its meaning. The guidance on this page is general, not taken from it.

The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.