Komatsu · Monitor user codes
Komatsu Fault Code E03
Swing parking brake system
What does Komatsu code E03 mean?
User code E03 means a fault in the swing parking brake system. The failure codes behind it are the swing brake solenoid circuits DW45KA and DW45KB. Urgency: check soon - the machine may derate or limit a function. Check first: read the failure codes in service mode to see whether DW45KA or DW45KB is active.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Read the failure codes in service mode to see whether DW45KA or DW45KB is active
Then 3 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 4 done
Causes
- Swing brake solenoid coil open or shorted
- Wire to the swing brake solenoid damaged
- Swing brake stuck or not releasing
How it failed
You'll notice: Caution or E03 on the monitor with swing that will not hold or will not release.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Operator user codes (E02, E03, E05, E10 and similar)
- E0ENetwork (data link) failureLost messageCheck soon
- E02PC-EPC systemOtherCheck soon
- E03Swing parking brake systemOtherCheck soon
- E05Governor motor systemOtherCheck soon
- E10Engine controller power or drive failureOtherCheck soon
- E11Engine control system failure, output limitedOtherCheck soon
- E14Feedback system failure (throttle circuit)OtherCheck soon
- E15Engine sensor failureOtherCheck soon
Other Komatsu codes: Monitor user codes
Related on Equipments Finder
Source
Komatsu Fault Codes List (SlideShare, PC200-8 user and failure codes)
This source lists E03 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
