EF Logo

Komatsu · Engine controller

Komatsu Fault Code CA441

Battery voltage low

What does Komatsu code CA441 mean?

The engine controller sees battery voltage below its working range. It can cause resets, hard starting or sensor codes. Urgency: check soon - the machine may derate or limit a function. Check first: measure battery voltage with the engine off and while cranking.

FaultCheckCA441Komatsu · Engine controller

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure battery voltage with the engine off and while cranking

Then 3 more checks
Code shows hereFAULTCA441

Where this code shows

Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.

Checks

0 of 4 done

Causes

  • Discharged or old battery
  • Corroded battery terminals
  • Alternator not charging
  • High resistance in the controller supply wire

How it failed

You'll notice: Engine controller reports low battery voltage with CA441.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Battery, charging and air heater

1 other code on this part is also shorted low (AB00KE). When they show together, start at the wiring and connector they share.

All 5 Battery, charging and air heater codes on one page

Source

SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)

This source lists CA441 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.