Komatsu · Engine controller
Komatsu Fault Code CA559
Common rail pressure too low (stage 1)
What does Komatsu code CA559 mean?
The rail pressure stays below the commanded value. The injectors may not deliver the full amount of fuel and the engine loses power or starts hard. Urgency: check soon - the machine may derate or limit a function. Check first: change the fuel filters and bleed the low pressure circuit before further tests.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Change the fuel filters and bleed the low pressure circuit before further tests
Then 4 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 5 done
Causes
- Restricted fuel filter or air in the low pressure line
- Worn supply pump
- Leaking injector or rail connection
- IMV valve stuck open
1 more causeFewer causes
- Water in the fuel
How it failed
You'll notice: Loss of power or hard starting with CA559 on the monitor.
Real conditionRead from how the source describes the code
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Common rail fuel pressure
2 other codes on this part are also real condition (CA553, CA2249). When they show together, start at the wiring and connector they share.
- CA449Common rail pressure too high (stage 2)Shorted highStop now
- CA451Common rail pressure sensor: high voltageShorted highCheck soon
- CA452Common rail pressure sensor: low voltageShorted lowCheck soon
- CA553Common rail pressure too high (stage 1)Real conditionCheck soon
- CA559Common rail pressure too low (stage 1)Real conditionCheck soon
- CA2249Common rail pressure too low (stage 2)Real conditionStop now
Other Komatsu codes: Engine controller
Related on Equipments Finder
Source
SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)
This source lists CA559 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
